![]() So I connected my audio 6 to route maschine. I tried with cdjs aggregate sound card but I have no sound. Important Note: You need to disable Direct Thru, or else the corresponding output channels of the TRAKTOR AUDIO 6 / 10 can not be used for playback with TRAKTOR DJ. I have downloaded Blackhole 2ch for the internal routing. I have watch countless videos and none really explain external mixer settings, just DJ controllers like S4. The below screenshot shows the correct Startup settings for use with TRAKTOR DJ on iOS. I am trying to setup OBS I use DJM900nxs2 external mixer but I cannot figure out the Audio Inputs and Audio Outputs within Traktor Scratch. *Tip: If your mic signal sounds a little weak you can either turn up the Trim in the Inputs tab, or turn the MicroBook II's physical trim knob on the box.Īnd that's it! That's how you set up the MicroBook II to output both a microphone and a signal from iTunes out of Main Out 1-2 and Phones 1-2 (and in this case, Line 1-2 as well- which, FYI: is labeled Line Out 3-4 on the physical unit itself. How to route maschine to traktor via 2 cdjs nxs2. Disable Direct Thru by unchecking the corresponding checkboxes. Now, when your Mic 1 and Aux 1-2 are unmuted, and the faders turned up, this signal will be going out of Main Out 1-2, Line Out 1-2, and Phones Out 1-2.ĩ. In this example, I've set Main Out 1-2, Line 1-2 and Phones 1-2, all to Mix 1, so if you look back at the Mixes tab shot, you'll notice the Main, Line, and Phones squares are illuminated blue. Next, check your Ouptuts tab to see outputs you've assigned to your current mix. ![]() Unmute Aux 1-2, and you should see signal in that channel.Ĩ. Then go to the CueMix FX application, which is found in Mac HD > Applications.ħ. You’ll also need: Traktor 2.5.1 (or higher) Maschine 1. As soon as you check Aux 1-2, audio is sent to all of MicrBook II's outputs. STEP ONE: GEAR UP This setup was accomplished with my Macbook, Traktor Kontrol S2, and Maschine Mikro so no external MIDI cable connections were possible (the Mikro and S2 don’t have the MIDI ports that other audio interfaces and controllers offer). or even other hosts like Pro Tools, Digital Performer, Logic, etc. That means anything that hosts audio such as iTunes, YouTube etc. Aux 1-2 is the channel that comes from your "host" or computer. If any other streams are checked, un-check them before continuing. Open up a new Audio Devices window if one is not already open, by going to Window > Show Audio Window.ģ. To get here, go to Mac HD > Applications > Utilities > Audio MIDI Setup.Ģ.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |